Nose for 60" Troll
SKU:
60NOSE
$6.00
$6.00
Has your 60" troll had an accident? :( Although the noses are usually the most vulnerable part of these trolls, they are often very easy to replace using a hot melt glue gun. Noses come in a variety of shapes and sizes. Most of the noses we will have are a light bulb/pear shape that vary in size between 4"-5" in diameter (slightly smaller than the one in this picture). If you have a local source for dried gourds you might be able to find one yourself that will work just as well, just make sure that it is a hard shell gourd like the ones we use.
The shipping cost is the main expense in getting this to you, so it would be best if you were able to include this with your next troll order since we charge a flat rate (per order) shipping charge.
For nose surgery; Prepare your tools (Preheat your hot melt glue gun). And of course...make sure you follow the safety precautions for using this hot glue. Have your troll lay on it's back, or lean it over backward against a low solid object like a table or couch. Carefully remove the loose nose parts from original. Once your troll is ready, apply a reasonable amount of hot melt glue in area where new nose will attach. Grasp new nose by front side and set firmly in place in the desired position (taking care not to touch hot glue with hand!). Hold nose for a few minutes until glue cools. That's it. Your troll should be feeling much better immediately and will be very grateful !
Please contact us with any questions. Don't have a glue gun? A number of other adhesives will also work but these take longer to set.
The shipping cost is the main expense in getting this to you, so it would be best if you were able to include this with your next troll order since we charge a flat rate (per order) shipping charge.
For nose surgery; Prepare your tools (Preheat your hot melt glue gun). And of course...make sure you follow the safety precautions for using this hot glue. Have your troll lay on it's back, or lean it over backward against a low solid object like a table or couch. Carefully remove the loose nose parts from original. Once your troll is ready, apply a reasonable amount of hot melt glue in area where new nose will attach. Grasp new nose by front side and set firmly in place in the desired position (taking care not to touch hot glue with hand!). Hold nose for a few minutes until glue cools. That's it. Your troll should be feeling much better immediately and will be very grateful !
Please contact us with any questions. Don't have a glue gun? A number of other adhesives will also work but these take longer to set.
